Design a Bust

the first thing i did to my car was to get rid of that computer,my home computer works better, anyways some people say it will bend the valves,thats just not true, unless they are already bent, i have bin running water with my gasoline for about 20 or 25 years now, well look at the bock 1-11 aircraft, it uses water to boost on take-off, just to get off the ground, there's is no runway that long, and your air speed needs to be about 125 or better for lift-off, so i run water in my car, if it has a computer, i try to rip it out, in my state the emmisions testing limits are .31, when i went in for testing i got a .07, sure i turned down the idel to about 550 rpm's when it was said to run it at 950 rpm's, plus i had a switch on my fan, so i could heat the engine up a little about 475F, plus i had half a tank of ave gas about 130 octane, to crap gasoline= a full tank of fuel, i passed then ,i did it again for an extra 10 bucks, just to see if i got the same .07, no this time it was .06, well what am i going to do, so i framed the test and put it up on my wall, just so everybody could see what my tests were, no smog,no steam. like some cars that my eyes are watering because of all the unburnt gas comming out the tail pipe, don't peop[le do tune-ups anymore?, or maybe just after it dies, i use bocth 4 way plugs good for 100,000 miles, they burn all the fuel, but wait i put in a stronger coil the stock one was rated at 30,000 volts, i put in a power coil at 49,000 volts, maybe that's it, i don't like to waste my fuel, i like to burn it all, plus a little water on the side.......good day..

1  out of 1 found this valuable. Do you find this valuable? Do you?    

I've also got a 1/20 scale with a 7hp motor, so its not just the1/5 scales that go super fast.

0  out of 1 found this valuable. Do you find this valuable? Do you?    

I remember the divers used to call the stuff primer cord. I believe the army guys called the same stuff detcord but it did the same job. I remember they used the stuff to remove our starboard prop after it got damaged in a storm. A part of our boat (submarine)came off and hit the propellor. They used a crane with cables attached to the prop and unbolted the prop and wrapped primer cord around the shaft in front of the prop and detonated the cord which then the prop was pushed off the shaft. It saved us from going into drydock to have that job done.
With bill0759,s numbers I went to my computer and got this calculation of 11000 feet per second which came out to about 2.08 miles per second or over 7800 miles per hour air speed which is a little over 9.8 times the speed of sound. So at that speed I could make it from my house in New Hampshire to M5 in San Francisco in about 1/2 hour. I still wonder if detcord or primer cord is the fastest burning stuff around.

1  out of 1 found this valuable. Do you find this valuable? Do you?